Hi Andrew,
please find below the Details/ Log :
* Starting identification process...
* Checking for known running web servers...
* Checking for SNMP protocol support on system...
Normal: The system did not respond to SNMP. Verify security settings and
community strings in Options->Security->Credentials->System
Credentials
* Checking for SNMPv3 protocol support on system...
Normal: The system did not respond to SNMPv3. Verify security settings and
v3 credentials in Options->Security->Credentials->System
Credentials
* Running HP ProLiant management agent identification...
Normal: The system does not support SNMP.
* Running SNMP base cluster identification using common cluster
MIB...
Normal: SNMP is not supported or globally disabled, skipping SNMP cluster
identification.
* Checking for WBEM protocol support on system...
Major: The identification or discovery of this system has timed out, so
the task for this target has failed. If the managed system's CPU is
heavily utilized, then you may want to increase the timeout value
for identification for a single system. To do that, increase the
IdentificationTaskDefaultThreadTimeoutSec property in the
globalsettings.props file to 1800 (30 minutes) or more using the
mxglobalsettings CLI command. For more information, see the online
help.
I don't think it had anything regarding increasing the "TIMEOUT Value" bec it 30 Minutes :)
ive tired to uninstall the "WMIMapper" and install it again , stop/start the "Pegasus WMI Mapper" service" but still the same result .
*I've entered the correct credentials.
*Trying to identify esxi servers.
And also note that this issue keeps come and goes .
Sorry for the late reply.
