Hi,
I have 17 D2D devices which I have been asked to monitor using HPSIM 7.2. They are 2502i's 2504i's 4324's and 4210's. I have added the MIB's I have created a new object type and followed all the documentation and during discovery all but 3 have shown correctly.
I am having an issue with the 4210 because HPSIM doesnt recognise the device type and I cannot find any MIBS for it or looking at the documentation I cant see what is required to get it to work. but also I have 2x 2504i's that dont work, now the MIBS say they are for 2504i's but when I log onto these they say they are HP StorageWorks D2D2504i - G02-E where all the other 2504i's say they are HP StorageWorks D2D2504i - G02 only. I cannot find out what the difference is between the G02 and the G02-E but that is what appears to be making insight not be able to tell what it is. All software versions are 2.2.18 and I have been told the same software source code was used on got versions of hardware with no issues seen.
Has anyone else had this issue? or could anyone else tell me something to try? I am using SNMP and SSH for discovery. and an example failure is below.
********* Significant issues and overall target discovery/identification
status:
Major: The system cannot be identified properly for HP SIM to manage;
unable to get one or more of the following: model, serial number or
unique identifier (UUID). For management processors, verify the
system is running the latest firmware. For Linux based operating
systems, you must have dmidecode installed, enable the
PermitRootLogin and PasswordAuthentication in sshd, and use root
sign-in credential. For HP-UX, verify the sign-in credential. For
Windows, check if WMIMapper is configured correctly on the CMS and
verify the sign-in credential.
Critical: The system(s) can not be identified by WBEM, SNMP or SSH
Thanks
